Stained Nitroemalyami Surface
The use of nitrocellulose lacquer and nitroemaley allows high-speed finishing techniques as well as hardening of the films nitrosostavov occurs rather quickly, within 1-2 hours. The surface is better to by pnevmoraspyliteley (quick drying of the film makes applying the enamel with a brush). It should be borne in mind that produced modern industry nitroemali NC-132, SC-25 (respectively, paint coatings) have excellent physical and chemical properties, provided the printing of the prepared surface. Therefore, before painting should be carefully prepared to be painted. If this wall, you should wash well their detergent and allow to dry. Areas with chipped old paint should be cleaned with a scraper, and then align the stopper. When the putty thickens – rub a fine-grained sandpaper.
In preparation for the painting wood surfaces, first remove the dirt and irregularities of the old paint. Then washed the surface with detergent and then water. Cracks and holes are sealed filler, after drying, which surface is polished with sandpaper. Before painting the surface or apply a prime coating nitro primer GF-021. Nitro (the most common enamel NTs-132 and SC-25) usually available in a ready-to-eat form.
Since they dry very quickly, then they should be painted at a rapid pace along the grain twice with an interval of 40-50 min. It is best to apply nitroemali using special spray guns. Before painting the necessary check the paint on the sample: if the wood is painted, then as the sample used the same piece of wood, if the color is subject to the metal – a piece of metal. You should not mix paint with an electric light or the sun and merging together the remnants of various paints. If necessary nitroemali diluted with solvents 646 or 648.